Hudson Robotics Bar Code Print and Apply - Manual (Page 17)

Print and Apply User Manual Hudson Robotics, Inc.
15
6. Press the (Next-Save) button until the tear off setting is displayed,
using the (+) and (–) buttons move the label until it is in the correct
location.
7. Remove that label and press the feed button again 2-3 times to confirm
the proper tear off location.
8. To save the tear off position press the (Setup-Exit) button, this will
send it to the save options, the first option will be Save Permanently,
press the (Next-Save) to accept the save command.
9. After the settings have been saved correctly the printer will
automatically go back to Main screen, where it shows Printer Ready.
*The tear off position may need to be adjusted if the media is removed to clean the
printer or when a new media/ribbon roll is installed.
** Must allow 25 labels to be printed trough the printer when a new roll is installed,
since it needs time to find its natural resting location.