Hudson Robotics Bar Code Print and Apply - Manual (Page 16)

Print and Apply User Manual Hudson Robotics, Inc.
14
C. Hardware Setup
Prior to Label Setup, the hardware must be configured to pick up labels properly. The
apply head can be controlled from the label retrieval or apply head setup screens.
1. Move the apply head out of the way of the air blast.
2. Press the Feed button on the front of the printer to advance one label to
the tear off position.
3. The label should stop right at the edge of the strip bar as seen below.
4. If the label is not in the correct location, it will have to be adjusted
through the printer’s front panel.
5. To get into the submenus, press the (Setup-Exit) button on the front
panel of the printer.
Feed Button
Air Blast
Strip Bar