Parksense® rear park assist — if equipped, Parksense® sensors, Parksense® rear park assist — if – Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 178: Equipped

Advertising
background image

WARNING!

Electronic Speed Control can be dangerous where the
system cannot maintain a constant speed. Your ve-
hicle could go too fast for the conditions, and you
could lose control and have an accident. Do not use
Electronic Speed Control in heavy traffic or on roads
that are winding, icy, snow-covered or slippery.

PARKSENSE® REAR PARK ASSIST — IF
EQUIPPED

The ParkSense® Rear Park Assist system provides visual

and audible indications of the distance between the rear

fascia and a detected obstacle when backing up, e.g.

during a parking maneuver. Refer to “ParkSense® Sys-

tem Usage Precautions” for limitations of this system and

recommendations.

ParkSense® will retain the last system state (enabled or

disabled) from the last ignition cycle when the ignition is

changed to the ON/RUN position.
ParkSense® can be active only when the shift lever is in

REVERSE. If ParkSense® is enabled at this shift lever

position, the system will remain active until the vehicle

speed is increased to approximately 11 mph (18 km/h) or

above. The system will become active again if the vehicle

speed is decreased to speeds less than approximately

10 mph (16 km/h).

ParkSense® Sensors

The four ParkSense® sensors, located in the rear fascia/

bumper, monitor the area behind the vehicle that is

within the sensors’ field of view. The sensors can detect

obstacles from approximately 12 in (30 cm) up to 59 in

(150 cm) from the rear fascia/bumper in the horizontal

direction, depending on the location, type and orienta-

tion of the obstacle.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 177

Advertising