General information, Remote starting system — if equipped – Dodge 2014 Challenger_SRT - Owner Manual User Manual

Page 30

Advertising
background image

3. To reassemble the RKE transmitter case, snap the two

halves of the case together. Make sure there is an even

“gap” between the two halves. If equipped, install and

tighten the screw until snug. Test RKE transmitter

operation.

General Information

This device complies with Part 15 of the FCC rules and

RSS 210 of Industry Canada. Operation is subject to the

following conditions:

• This device may not cause harmful interference.
• This device must accept any interference received,

including interference that may cause undesired op-

eration.

NOTE:

Changes or modifications not expressly approved

by the party responsible for compliance could void the

user’s authority to operate the equipment.

If your RKE transmitter fails to operate from a normal

distance, check for these two conditions:
1. A weak battery in the transmitter. The expected life of

the battery is a minimum of three years.

2. Closeness to a radio transmitter such as a radio station

tower, airport transmitter, and some mobile or CB

radios.

REMOTE STARTING SYSTEM — IF EQUIPPED

This system uses the Remote Keyless Entry

(RKE) transmitter to start the engine conve-

niently from outside the vehicle while still

maintaining security. The system has a range of

approximately 300 ft (91 m).

2

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29

Advertising