FRIGIDAIRE FGHB2866PP - Manual (Page 14)

CAUTION
Wear gloves and safety goggles. Use extreme CAUTION when installing these handles.
14
INSTALLING DOOR HANDLES
Door Handle Mounting
Instructions for Frigidaire
Gallery ®
1 Remove handles from carton and any
other protective packaging.
2 Position fresh food handle end
over upper and lower pre-installed
shoulder bolts (A) that are fastened
into door, ensuring the holes for the
set screws are facing towards the
opposite door.
3 While holding handle firmly against
door, fasten upper and lower Allen set
screws (B) with supplied Allen wrench.
4 Repeat steps 2 and 3 to install
opposite handle. Ensure the holes for
the set screws are facing towards the
first door.
5 Position freezer handle end over
left and right pre-installed handle
mounts that are fastened to the
door, ensuring the holes for the set
screws are facing down.
6 While holding handle firmly against
door, loosely tighten far right Allen
set screw (B) with supplied Allen
wrench until there is no gap between
handle and door.
7 Still holding the handle firmly to the
door, firmly tighten far left Allen set
screw (B) with supplied Allen wrench.
8 Return to the far right Allen set
screw (B) and firmly tighten with
supplied Allen wrench.
Mounting Refrigerator Handles
Mounting Freezer Handle

NOTE
All set screws should be tightened so the screw is below the surface of the handle. The handles
should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door
while tightening the Allen screw makes installation easier.
The door handle may loosen over time or if it was installed improperly. If this happens, tighten the
set screws on the handles.