FRIGIDAIRE FGHB2866PP - Manual (Page 31)

31
CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water filtering
system. The water filter system filters all
dispensed drinking water, as well as the water
used to produce ice.
Water Filter
The water filter is located at the top right side of
the fresh food compartment.
Ordering Replacement Filters
To order your replacement filters, please visit our
online store at www.frigidaire.com/store, by calling
toll-free at 877-808-4195, or by visiting the dealer
where you purchased your refrigerator. Frigidaire
recommends that you order extra filters when you
first install your refrigerator, and that you replace
your filters at least once every six months.
Here is the product number to request when
ordering:
PureSource Ultra
TM Water Filter
Part #ULTRAWF
Replacing the Water Filter
In general, you should change the water filter every six
months to ensure the highest possible water quality.
Water Filter Status on the user interface prompts
you to replace the filter after a standard amount of
water (200 gallons/757 liters for PureSource Ultra TM )
has flowed through the system.
If your refrigerator has not been used for a period
of time (during moving for example), change the
filter before reinstalling the refrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra TM ice and water filter
• Rated service flow - .50 gallons per minute
• Operating Temp: Min. 33° F, Max. 100° F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure:
30 pounds per square inch
To replace your PureSource Ultra TM water filter:
It is not necessary to turn the water supply off
to change the filter. Be ready to wipe up any
small amounts of water released during the filter
replacement.
1 Turn Off the ice maker power switch.
2 Remove the filter by pushing on the end/face
of the filter.
3 Slide the old water filter cartridge straight out
of the housing and discard it.
4 Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snap-in
connector at the back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at the
filter housing. Any spurts and sputters that
occur as the system purges air out of the
dispenser system are normal.
7 After filling one glass of water, continue
flushing the system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
The PureSource Ultra TM ice and
water filter system is tested and
certified to NSF/ANSI Standards 42 and
53 for the reduction of claims specified
on the performance data sheet.
More about your Advanced Water
Filter

NOTE
When ordering your replacement filter, please
reorder the same filter type that is currently in
your refrigerator.