FRIGIDAIRE FGHB2866PP - Manual (Page 19)

19
options
(∧ or ∨)
Used to enter and exit the
options menu and make
selections.
exit Toggles the options and run
modes.
control
locked
While in the locked state, you
will not be able to change any
settings on the display nor
dispense ice and water. The
“Control Locked” indicator will
flash and an audible warning
tone is played.
quick
freeze on
off
Activates a faster rate for
freezing food and increases
ice production in the freezer.
Deactivates after 12 hours.
ice maker
on off
Toggles the ice maker in the
refrigerator compartment “ON”
or “OFF”. In the “Off” state, the
indicator will blink when ice is
dispensed.
display
on off
Toggles the temperature
displays On and Off.
refrigerator
temp
Allows the temperature set-
points to be adjusted. Control
temperatures range from +33°F
/ +1°C to +47°F / +8°C.
freezer
temp
Allows the temperature set-
points to be adjusted. Control
temperatures range from -6°F /
-21°C to +6°F / -15°C.
mode
°F °C
Toggles display from Fahrenheit
to Celsius.
light Toggles dispenser light On and
Off.
power off Press and hold for three seconds
to turn off the cooling system.
It also turns off the ice maker
and all dispenser functions. The
display will read “power off”.
water filter Displays the current status of
the water filter (Good, Order,
or Replace). To reset the filter
status to “Good”, press and hold
the “set” key for three seconds.
air filter Displays the current status of
the air filter (Good, Order, or
Replace). To reset the filter
status to “Good”, press and hold
the “set” key for three seconds.
default
settings
While in the default option,
press and hold the set key
for three seconds to reset all
refrigerator settings to their
factory default settings.
set (+ or -) Selects the current menu
selection option.
water Press the “water” key to select
water. A green indicator light will
be illuminated above the active
feature.
cube Press the “cube” key to select
cubed ice. A green indicator
light will be illuminated above
the active feature.
crush Press the “crush” key to select
crushed ice. A green indicator
light will be illuminated above
the active feature.
CONTROLS
Setting cooling temperatures
(options may vary)

NOTE
When you first power on the refrigerator, the
temperature displays 0°F and 37°F. After a
few seconds, both of the displays will switch to
“HI”. The displays will continue to show “HI” for
20 minutes. After 20 minutes, the High Temp
alarm will sound and both displays will show
the actual temperature.
1 Plus (+) and Minus (-) indicators are located
on the right side of the control panel.
2 Press the + or - indicator to adjust the
temperature to the desired setting.
Options May Vary