FRIGIDAIRE FGHB2866PP - Manual (Page 34)

34
CARE & CLEANING
Care & Cleaning Tips
Part What To Use Tips and Precautions
Interior & Door
Liners
• Soap and water
• Baking soda and water Use two tablespoons of baking soda in one
quart of warm water. Be sure to wring
excess water out of sponge or cloth before
cleaning around controls, light bulb or any
electrical part.
Door Gaskets • Soap and water Wipe gaskets with a clean soft cloth.
Drawers & Bins • Soap and water Use a soft cloth to clean drawer runners and
tracks.
Glass Shelves • Soap and water
• Glass cleaner
• Mild liquid sprays Allow glass to warm to room temperature before
immersing in warm water.
Toe Grille • Soap and water
• Mild liquid sprays
• Vacuum attachment Vacuum dust from front of toe grille. Remove
toe grille (see Installation Instructions). Vacuum
backside, wipe with sudsy cloth or sponge. Rinse
and dry.
Exterior &
Handles
• Soap and water
• Non Abrasive Glass
Cleaner
Do not use commercial household cleaners
containing ammonia, bleach or alcohol to clean
handles. Use a soft cloth to clean smooth
handles. DO NOT use a dry cloth to clean
smooth doors.
Exterior &
Handles
(Stainless Steel
Models Only)
• Soap and water
• Stainless Steel Cleaners Never use CHLORIDE or cleaners with
bleach to clean stainless steel.
Clean stainless steel front and handles with non-
abrasive soapy water and a dishcloth. Rinse with
clean water and a soft cloth. Use a non-abrasive
stainless steel cleaner. These cleaners can be
purchased at most home improvement or major
department stores. Always follow manufacturer’s
instructions. Do not use household cleaners
containing ammonia or bleach.
NOTE: Always clean, wipe and dry with
the grain to prevent scratching. Wash the
rest of the cabinet with warm water and mild
liquid detergent. Rinse well, and wipe dry with a
clean soft cloth.
Replacing Light
Bulbs
• Unplug refrigerator
• Wear gloves
• Remove light cover
• Replace old bulb
• Replace light cover
• Plug in the refrigerator CAUTION: Wear gloves when replacing
light bulbs to avoid getting cut.
Use same wattage when replacing bulb.