FRIGIDAIRE FFRG1001PW - Manual (Page 17)

17
REVERSING DOOR
1 Open door and remove four plugs in the door opening
opposite the hinges. Retain all parts for use later,
unless otherwise noted. (Figure below)
2 Begin removing the four short screws that attach the
hinge to the front panel. (Figure Above) Start by only
removing one screw per hinge. Then only loosen the
two remaining screws while fi rmly holding the door to
prevent damage to hinge, front panel or door. After the
remaining screws are loosened, continue to remove all.
3 Place door on a towel (front side down) to prevent
scratches to paint or window (if equipped). Remove
all four remaining long hinge screws on edge of door.
(Figure below)
1 Be sure you have adequate swing area
before reversing door.
2 You will need a screw driver with a #2 square
bit and a pair of pliers.
3 Protect fl at work surface, such as top of dryer
or fl oor near dryer, with a soft cloth or towel.
4 Be sure dryer is unplugged from power source!
Tools needed:
Your dryer is designed so the door swing may be reversed at any time without additional parts. Conversion is
accomplished by transferring hinges and door strike to the opposite sides of the cabinet.
Screwdriver with #2
square bit
Adjustable
pliers
4 Remove the four long screws from edge of door
opposite hinges. (Figure above)
HOLE PLUGS (x 4)
FRONT PANEL
HINGE SCREWS (x 4)
DOOR HINGE
SCREWS (x 4)
“D” STAMPED ON
DOOR SIDE OF
HINGE INTERIOR
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in
personal injury or even death.
NOTE
You may need a plastic knife to help pull out the plugs.
Be careful not to scratch the paint.
NOTE
Observe the “D” stamped on the interior of the hinge
on the door side. When reversed to the other side, this
“D” must be visible after the hinge is remounted.
DOOR EDGE
SCREWS (x 4)