FRIGIDAIRE FFRG1001PW - Manual (Page 19)

19
ACCESSORIES
LP CONVERSION KIT
P/N PCK4200
Gas dryers intended for use in a location supplied with LP
must use a conversion kit prior to installation.
MOBILE HOME INSTALLATION KIT
P/N 137067200
Installation in a mobile home requires the use of a
MOBILE HOME INSTALLATION KIT.
DRYING RACK (FOR USE WITH MODELS EQUIPPED
WITH MOISTURE SENSING BARS)
P/N 137067300
Depending on the model you purchased, a drying rack
may have been included in the initial purchase of your
dryer. If your model did not include a drying rack or you
desire another drying rack, you may order one.
UNIVERSAL APPLIANCE WRENCH
P/N 137019200
A UNIVERSAL APPLIANCE WRENCH is available to aid in
dryer/washer/pedestal feet adjustment.
TOUCH UP PAINT PENS*
Classic White Touch Up Pen - P/N 5304468812
*Other colors may be available. Contact the source where you
purchased your dryer.
CAUTION
Failure to use accessories manufactured by (or
approved by) the manufacturer could result in personal
injury, property damage or damage to the dryer.
WARNING
ELECTRICAL SHOCK HAZARD
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
Replacement parts:
Technical Sheet/Wiring Diagram:
If replacements parts are needed for your dryer, contact
the source where you purchased your dryer or refer to
your Use and Care Guide for more information.
To remove the console faceplate follow the directions
below:
1. Disconnect dryer from electrical source.
2. Remove the two screws toward the top on the back of
the console housing.
3. Insert a small screw driver through each hole on the
back of the console housing and gently press inward
to disengage each upper faceplate retaining tab.
4. Gently lay the console faceplate forward to access
technical/wiring diagram.
5. When fi nished with repair, return sheet inside console,
ensure lower retaining tabs are in place and snap
faceplate to upper retaining tabs. Reinsert the two
screws removed earlier.
NOTE
A wiring diagram and technical data sheet are located
inside the dryer console.
TECH DATA SHEET/
WIRING DIAGRAM