Local management overview, Management agent, Local vs. remote management – Cabletron Systems Cabletron CyberSWITCH CSX400 User Manual
Page 140: Outlines the contents of this chapter
General Configuration Using Local Management
126
CSX400 and CSX400-DC User’s Guide
describes how to configure the CSX400 for IPX routing functions.
describes how to configure the CSX400 for a Wide Area Network (WAN) interface.
Local Management Overview
Cabletron Systems Local Management is a management tool that allows a network manager to
perform the following tasks:
•
Configure interconnected devices to form a network.
•
Monitor the performance of the network.
•
Control user access to the network and its components for the purpose of security.
Management Agent
The management agent is a process within the CSX400 that collects information about the
operational performance of the managed network. Local Management communicates with the
management agent for the purpose of issuing management commands to network devices.
Local vs. Remote Management
Network management applications are usually described as either local or remote management
applications. A Local Management application resides within the circuits of the CSX400
management agent and is accessible by making a TELNET connection through one of the two
EPIM ports located on the front panel of the device. Remote management applications such as
Cabletron Systems SPECTRUM, SPECTRUM Element Manager, or QuickSET run in another
device that provides management services. This allows you to perform network management from
a remote location.
NOTE
If you have a WPIM-HDSL installed in your CSX400, refer to the WAN Setup section of
this chapter for configuration information. For all other WPIMs, refer to your specific
WPIM(s) Local Management Guide for information on this screen
.