Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 145)

General Configuration Using Local Management
CSX400 and CSX400-DC User’s Guide 131
3. Repeat steps 1 and 2 until the Main Menu screen displays.
4. Use the arrow keys to highlight the EXIT command at the bottom of the Main Menu screen.
5. Press ENTER. The CSX400 Local Management Password screen displays and the Local
Management session ends.
Establishing a TELNET Connection
The CSX400 is shipped with a temporary IP Address of 192.168.254.254 so that your computer
can communicate with it over your Local Area Network (LAN) through a TELNET connection.
However, to establish a TELNET connection, your computer must be on the same subnet as the
CSX400. Cabletron Systems recommends that you assign a temporary IP Address of
192.168.254.253 to your computer to ensure that both devices are on the same subnet. TELNET
connections to the host device require the community name passwords assigned at the SNMP
Community Names screen or if you are doing an initial configuration, use the default password
public. Refer to the SNMP Community Names section of this manual for additional information
about community names.
Local Management Screen Hierarchy
Local Management consists of a series of menu screens that provide a path to each of the Local
Management function screens. Navigate through Local Management by selecting items from the
menu screen.
Figure 55 shows the hierarchy of the Local Management screens.
Figure 55 Hierarchy of Local Management Screens
NOTE
See the instructions included with the TELNET application for information about
establishing a TELNET session.
Main Menu Password
Setup Menu
System Level
SNMP Community Names
SNMP Traps
MIB Navigator
Flash Download
Bridge Setup
Router Setup
WAN Setup
IP
IPX
IP Configuration
IP RIP
IPX Configuration
IPX RIP
IPX SAP