Cabletron Systems Cabletron CyberSWITCH CSX400 - Manual (Page 237)

CSX400 and CSX400-DC User’s Guide 223
B
WPIM Cable Specifications
WPIM-T1
This section provides the Cabletron Systems part number and connector specifications for
WPIM-T1 interface cables.
Table 33 provides connector type and part number information.
Table 34 provides RJ48 connector pin assignments.
NOTE
For all WPIM cables, there is part number information for ordering a standard 20-foot
cable or a specified length of cable. The number 20 followed by the part number
denotes the standard 20-foot cable. The letter “L” denotes the specified length required
in feet or meters. For example: 9372095-3 denotes a 3 foot cable; 9372095-3M
denotes a 3-meter cable.
Table 33 T-1 Interface Cable Part Numbers
Connector Type Part Number
RJ48C 9372094
Table 34 T-1 Connector Pin Assignments
Pin Signal
1 Receive Ring
2 Receive Tip
3 Not Used
4 Transmit Ring
5 Transmit Tip
6 Not Used
7 Shield Ground
8 Shield Ground