Compaq MP3800 - Manual (Page 32)

3–10 Compaq iPAQ Microportable Projector MP3800 User’s Guide
Using the On-Screen Display Menu
■ Adjusting—Indicates the Resync button has been pressed or
the Factory Reset option has been selected from the OSD
menu. The message will disappear when the appropriate
mode is detected and displayed by the projector.
■ Multiple inputs are active. Use the OSD to select the
alternate sources—The projector has detected multiple
inputs. This message may appear when powering up,
returning from Standby, or when the
Source button is pressed
on the remote control. If no selection is made within 10
seconds, the currently displayed source will remain as the
active source. Press the
Source button on the remote control to
review and select from the active video sources.
■ Lamp May Fail Soon. Replacement Suggested—Indicates
the lamp is approaching failure. The message will remain on
the screen for 10 seconds or until the on-screen
Menu button is
pressed. This message appears once when powering up or
returning from Standby until the lamp is replaced. After the
lamp is changed, access the Service menu to reset the lamp
hours counter. Refer to the “Replacing the Projector Lamp
Module” section of Chapter 7 for information on resetting the
lamp hours counter.
✎
The 10-second timeout is the default value. To change the timeout
value, select the Management menu, select the OSD Timeout
menu, and change the timeout from 1 to 40 seconds.
✎
When the projector is started, the Compaq banner displays for
approximately 10 seconds. To skip this banner display, turn off
the function using the OSD menu.
281124-001.book Page 10 Tuesday, April 30, 2002 10:00 AM