Compaq MP3800 - Manual (Page 51)

Care and Maintenance
Compaq iPAQ Microportable Projector MP3800 User’s Guide 7–3
Replacing the Projector Lamp Module
Å
WARNING: When the lamp reaches its end of life, it may pop or
rupture. To reduce the risk of personal injury, be careful when removing
the lamp cover as broken glass may be present. Never open the lamp
cover while the projector is operating or when the lamp is hot.
The projector will alert you when the lamp approaches its failure
mode or end of life. When the message “Lamp May Fail Soon.
Replacement Suggested” displays on the projection screen, you
should change the lamp as soon as possible. Contact your local
Compaq authorized dealer, seller, or reseller to purchase a spare
lamp or have the lamp changed. To locate a reseller near you,
refer to the Worldwide Telephone Numbers booklet that came
with your projector. You can also purchase a lamp directly
through
http://www.compaq.com/products/projectors.
Follow these steps to replace the projector lamp module:
1. Turn off the projector by pressing the Power/Standby button on
the top of the projector.
2. Allow the projector to cool down for at least 30 minutes.
Å
WARNING: The lamp assembly operates at a very high temperature. To
reduce the risk of personal injury, allow the projector to cool down for at
least 30 minutes before opening the lamp cover. Never open the lamp
cover while the projector is operating or when the lamp is hot.
281124-001.book Page 3 Tuesday, April 30, 2002 10:00 AM