Dell Inspiron 23 (5348, Early 2014) - Manual (Page 68)

Replacing the Optical Drive
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Route the power cable and data cable through the routing guides on the
display-panel base.
2 Align the screw holes on the interposer with the screw holes on the
display-panel base.
3 Replace the screws that secure the interposer to the display-panel base.
4 Connect the power and data cables to the system board.
5 Align the screw holes on the optical-drive bracket with the screw holes
on the optical drive.
6 Replace the screws that secure the optical-drive bracket to the optical
drive.
7 Align the tabs on the optical-drive bezel with the slots on the optical-
drive assembly and snap it into place.
8 Slide the optical-drive assembly into the optical-drive bay until it snaps
into position.
Post-requisites
1 Replace the I/O bracket .
2 Replace the power-supply diagnostic board .
3 Replace the VESA-mount bracket .
4 Replace the system-board shield .
5 Replace the back cover .
6 Replace the stand assembly .
68