Dell 3330dn Mono Laser Printer - Manual (Page 117)

Restoring Factory Defaults
Wait for the message to clear.
When factory default settings are restored:
• All downloaded resources in the printer memory are deleted. This includes fonts, macros, and symbol sets.
• All settings return to the factory defaults except the Display Language setting in the Setup menu and the custom
settings in the Serial <x>, Network, Infrared, LocalTalk, and USB menus.
Routine maintenance needed
Standard Bin Full
Remove the stack of paper from the standard exit bin to clear the message.
Stopping
Wait for the message to clear.
Submitting selection
Wait for the message to clear.
Too many failed panel logins
The printer is now in a lockout mode because:
• You attempted to log in too many times with an incorrect PIN
• You attempted to log in using an incorrect password number for access to a printer feature, setting, or menu that
you do not have access to.
Note: There is a defined limit on the number of login attempts. Once the limit is reached, this message appears and
the printer enters a lockout mode. The message remains on the printer control panel, and any further attempts to
enter menus is denied until the defined time out expires. The time out duration is set by your system support person.
Wait for the message to clear once the time out expires, and then:
• Enter the correct PIN to access any held jobs
• See your system support person if you need a password number to enter a specific printer feature, setting, or
menu that is blocked from your use without the number.
Tray <x> disabled
The specified tray is disabled from the Disable Hardware menu of the Config menu. To clear the message, enable the
specified tray through the same menu. Consult your system support person for help.
Tray <x> Missing
Insert the specified tray into the printer.
USB/USB <x>
The USB port is the active communication link. The printer is processing data through the specified USB port.
Understanding printer messages
117