Dell Latitude D630 XFR (Early 2008) - Manual (Page 67)

Dell TM XFR D630 Fully Rugged Notebook Service Manual
Page 67 of 106 Revision A01
1. Follow the instructions in
133H
Before You Begin.
2. Install the display panel (see
134H
Installing the Display Panel).
3. Install the display bezel (see
135H
Installing the Display Bezel).
4. Install the display assembly (see
136H
Installing the Display Assembly)
NOTE: Ensure the display cable grommets are properly installed by following the instructions
provided at the beginning of
137H
Installing the Display Assembly.
10.9 Removing the Display Latch
CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User’s Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
NOTE: Replacing the display latch does not require removing the display assembly from the
base.
NOTE: Replacement keyboard/palm rest overlays are not included in the latch service kits.
1. Follow the procedures in
138H
Before You Begin.
2. Turn the computer top-side up, and then open the display all the way (160 degrees).
3. Remove the display bezel (see
139H
Removing the Display Bezel).
4. Remove the 2 latch screws and washers.