Dell Latitude D630 XFR (Early 2008) User Manual
Page 97
Advertising
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 97 of 106
Revision A01
17. Remove the VGA Door from the rear panel of the notebook (see
18. Remove the four 5-mm hex screws on the back of the computer.
19. To remove the system board:
a. Lift the lower corner near the speaker.
b. Grasp the system board next to the I/O dash board and lift up until the USB
connectors and the gasket on the right side clear the base.
c. While keeping the system board raised on the right side, push on the VGA connector
to clear the base. Pull the system board towards the front and right to clear the audio
ports and Wi-Fi switch on the left side, and lift out of the base.
System Board
Screw Locations
Advertising