Dell C1760NW Color Laser Printer - Manual (Page 133)

Understanding the Printer Menus 131
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
USB Port
Purpose:
To change the USB settings on your printer. The change takes effect after the printer is turned off and then on.
Values:
System Settings
Use the System Settings menu to configure a variety of printer features.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.
PowerSaver Time
Purpose:
To specify the time for transition to power saver mode.
Values:
Enter 5 in Sleep to put the printer in the Sleep mode five minutes after it finishes a job. This uses less energy, but
requires more warm-up time for the printer. Enter 5 if your printer shares an electrical circuit with room lighting and
you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer ready to operate
with minimum warm-up time. Select a value between 5 and 30 minutes for the Sleep mode if you want a balance
between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Sleep mode when it receives data from the
computer. You can also return the printer to the standby mode by pressing any button on the operator panel.
If the Auto-Off Timer feature turns off the printer, the printer cannot be turned back on automatically. To turn the
printer back on, physically turn the power switch of the printer to On.
Enable* Enables the USB interface.
Disable Disables the USB interface.
Sleep 5min.* Specifies the time taken by the printer before it enters Sleep mode
after it finishes a job.
Available Range:
5-30min.
Deep Sleep 6min.* Specifies the time taken by the printer before it enters Deep Sleep
mode after it goes into Sleep mode.
Available Range:
1–6min.
Auto-Off Timer *1 Off Disables the Auto-Off Timer.
On * 180min. * Specifies the time it takes to automatically turn off the printer after it
has entered Deep Sleep mode.
Available Range:
60–1440min.
*1 Auto-Off Timer feature is available only in certain regions.