Setting the ip address, Assigning an ip address, The operator panel – Dell C1760NW Color Laser Printer User Manual
Page 41: 7 setting the ip address
Setting the IP Address
39
7
Setting the IP Address
Assigning an IP Address
An IP address is a unique number that consists of four sections that are delimited by a period and can include up to
three digits in each section, for example, 111.222.33.44.
You can select the IP mode from Dual Stack, IPv4, and IPv6. If your network supports both IPv4 and IPv6, select
Dual Stack.
CAUTION:
Assigning an IP address that is already in use can cause network performance issues.
NOTE:
Assigning an IP address is considered as an advanced function and is normally done by a system administrator.
NOTE:
When you assign an IP address manually in IPv6 Mode, use the Dell™ Printer Configuration Web Tool. To open the Dell
Printer Configuration Web Tool, use the link local address. To check a link local address, see "Verifying the IP Settings" on
NOTE:
Depending on the address class, the range of the IP address assigned may be different. On Class A, for example, an IP
address in the range from
0.0.0.0
to
127.255.255.255
will be assigned. For assignment of IP addresses, contact
your system administrator.
You can assign the IP address by using the operator panel or using the Tool Box.
The Operator Panel
For more information on using your operator panel, see "Operator Panel" on page 77.
NOTE:
A Password is required to enter
Admin Menu
when
Panel Lock Set
is set to
Enable
. In this case, enter
the password you specified, and press
the
(Set) button.
1 Turn on the printer.
The Ready to Print message appears on the operator panel.
2 Press the
(Menu) button.
3 Press the button until Admin Menu appears, and then press the (set) button.
4 Ensure that Network appears, and then press the (set) button.
5 Press the button until TCP/IP appears, and then press the (set) button.
6 Press the button until IPv4 appears, and then press the (set) button.
7 Ensure that Get IP Address appears, and then press the (set) button.
8 Press the button until Panel appears, and then press the (set) button.
9 Press the button and ensure that Get IP Address appears.
10 Press the button until IP Address appears, and then press the (set) button.
The cursor is located at the first digit of the IP address.
11 Press the or button to enter the numbers for the IP address.
12 Press the button.
The next digit is selected.
13 Repeat step 11 and step 12 to enter all the digits in the IP address, and then press the (set) button.
14 Press the button and ensure that IP Address appears.
15 Press the button until Subnet Mask appears, and then press the (set) button.
The cursor is located at the first digit of the subnet mask.