Dell 968 All In One Photo Printer - Manual (Page 88)

5. Verify that the adapter can communicate over the network. For more information, see Verifying
Network Communication .
Entering a Different Wireless Network Configuration
1. From the Wireless Networks Found In Your Area screen, select I want to enter a different
configuration, and then click Next.
2. If the Network Name (SSID) you want to use is available, select it from the list, and then click
Next.
If the Network Name (SSID) is not available
a. Select I want to enter a different network name, and then click Next.
b. Enter the Network Name (SSID).
c. Select the appropriate Channel from the drop-down list. (Auto is the default.)
d. Select your Wireless Mode.
For Infrastructure Mode, select Access an existing network through a wireless
router (Infrastructure Mode) - Typical, and then click Next.
For additional setup instructions, see Manually Configuring the Adapter in Infrastructure
Mode .
For Ad-Hoc Mode, select Access other computers directly without using a
wireless router (Ad-Hoc Mode), and then click Next.
For additional setup instructions, see Manually Configuring the Adapter in Ad-Hoc Mode .
3. Select the appropriate security method, and then click Next. If no security was detected, go to
step 5 .
4. Enter the appropriate security key(s) for the network, and then click Next.
5. On the Apply and Verify Wireless Settings screen, check each network attribute to make sure
the settings are correct, and then click Next to apply the settings.
NOTE: Clicking Next prompts the setup utility to verify wireless communication with the
printer. The verification process can take up to 120 seconds.
6. Verify that the adapter can communicate over the network. For more information, see Verifying
Network Communication .
Manually Configuring the Adapter in Infrastructure Mode
To set up the adapter in Infrastructure Mode, the setup steps vary based on the security settings you
select.
If you don't want any security
1. From the Wireless Security Settings screen, select No Security, and then click Next.
2. On the Apply and Verify Wireless Settings screen, check each network attribute to make
sure the settings are correct, and then click Next to apply the settings.