Dell PowerEdge 2600 - Manual (Page 39)

Installing a Replacement ERA/O Card
1. To install the replacement ERA/O card in the system, perform the following steps:
a. Position the ERA/O card so that the card connector is directly over the connector on the system board and the mounting holes on the card line up
with the support posts on the system board.(see Figure 4 -19 ).
b. Press down until the ERA/O-card connector is fully seated in the connector on the system board and the support posts are secured in the
mounting holes on the card.
Figure 4-19. Installing the ERA/O Card
2. Reinstall the expansion-card guide:
a. Holding the expansion-card guide at a 45-five degree angle, insert the two tabs at the ends of the expansion-card guide base into the slots on
the system board (see Figure 4 -17 ).
b. Rotate the expansion-card guide down until the clip snaps securely onto the system board.
3. Reinstall any expansion cards that you removed (see " Installing an Expansion Card ").
4. Reinstall the front fan assembly (see " Replacing the Front Fan Assembly ").
5. Replace the cover (see " Replacing the Cover ").
6. Replace the bezel (see Replacing the Bezel ").
7. Connect a network cable to the 10-Mbps server management Ethernet connector on the system back panel.
8. Reconnect the system and peripherals to their electrical outlets, and turn them on.
CD/Diskette Drive
The CD/diskette drive assembly attaches to the side of the peripheral bay and connects to the IDE controller on the system board through a single ribbon
cable.
Removing the CD/Diskette Drive
NOTE: SCSI cables connected from an expansion card to the SCSI backplane board should be routed under the front fan assembly.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against