Dell PowerEdge 2600 - Manual (Page 50)

9. Press <F2> to enter the System Setup program, and check the System Memory setting.
The system should have already changed the value in the System Memory setting to reflect the newly installed memory.
10. If the System Memory value is incorrect, one or more of the memory modules may not be installed properly. Repeat step 1 through step 8 , ensuring
that the memory modules are firmly seated in their connectors.
11. Run the system memory test in system diagnostics.
Installing Memory Modules
1. Open the bezel (see " Removing the Bezel ").
2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
3. Remove the cover (see " Removing the Cover ").
4. Remove the cooling shroud (see " Removing the Cooling Shroud ").
5. Locate the memory module connectors in which you will install a memory module (see Figure 4 -29 ).
6. Press down and outward on the memory module connector ejectors, as shown in Figure 4 -30 , to allow the memory module to be inserted into the
connector.
Figure 4-30. Removing and Installing a Memory Module
7. Align the memory module's edge connector with the alignment key, and insert the memory module in the connector (see Figure 4 -30 ).
The memory module connector has an alignment key that allows the memory module to be installed in the connector in only one way.
8. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock the memory module into the
connector (see Figure 4 -30 ).
When the memory module is properly seated in the connector, the memory module connector ejectors should align with the ejectors on the other
connectors with memory modules installed.
9. Repeat step 5 through step 8 of this procedure to install the remaining memory modules.
10. Perform step 6 through step 11 of the procedure in " Performing a Memory Upgrade ."
Removing Memory Modules
1. Open the bezel (see " Removing the Bezel ").
2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
3. Remove the cover (see " Removing the Cover ").
4. Remove the cooling shroud (see " Removing the Cooling Shroud ").
5. Locate the memory module connectors from which you will remove memory modules (see Figure 4 -29 ).
6. Press down and outward on the memory module connector ejectors until the memory module pops out of the connector (see Figure 4 -30 ).
7. Repeat step 4 through step 6 of this procedure to remove any other memory modules.
8. Perform step 6 through step 11 of the procedure in " Performing a Memory Upgrade ."
Microprocessors
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.