Dell PowerEdge 700 User Manual
Page 5
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2.
Remove the bezel. See "
Removing the Bezel
" in "Troubleshooting Your System."
3.
Lay the system on its right side.
4.
Remove the cover. See "
Removing the Cover
" in "Troubleshooting Your System."
5.
Remove the PSWD_EN jumper plug.
to locate the jumper on the system board.
6.
Install the cover. See "
Replacing the Cover
" in "
Troubleshooting Your System
."
7.
Stand the system upright.
8.
Replace the bezel. See "
Installing the Bezel
" in "Troubleshooting Your System."
9.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
The existing passwords are not disabled (erased) until the system boots with the PSWD_EN jumper plug removed. However, before you assign a new
system and/or setup password, you must install the jumper plug.
10.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
11.
Remove the bezel. See "
Removing the Bezel
" in "Troubleshooting Your System."
12.
Lay the system on its right side.
13.
Remove the cover "
Removing the Cover
" in "Troubleshooting Your System."
14.
Install the PSWD_EN jumper plug.
to locate the jumper on the system board.
15.
Install the cover. See "
Replacing the Cover
" in "
Troubleshooting Your System
."
16.
Stand the system upright.
17.
Replace the bezel. See "
Installing the Bezel
" in "Troubleshooting Your System."
18.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
19.
Assign a new system and/or setup password.
To assign a new passwords using the System Setup program, see "Assigning a System Password" in your User's Guide.
Back to Contents Page
CAUTION:
See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.
NOTE:
If you assign a new system and/or setup password with the jumper plug still removed, the system disables the new password(s) the next
time it boots.