Dell PowerEdge 700 - Manual (Page 56)

l Error message indicates a processor problem.
l A heat sink is not installed for the processor.
Action
1. Ensure that you are running the latest BIOS version.
You can download the latest BIOS version from the Dell Support website at support.dell.com.
2. Run the appropriate online diagnostics test. See " Using Server Administrator Diagnostics " in "Running System Diagnostics."
3. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
4. Remove the bezel. See " Removing the Bezel ."
5. Lay the system on its right side.
6. Remove the cover. See " Removing the Cover ."
7. Remove the cooling shroud. See " Removing the Cooling Shroud " in "Installing System Options."
8. Ensure that the processor and heat sink are properly installed. See " Replacing the Processor " in "Installing System Options."
9. Install the cooling shroud. See " Installing the Cooling Shroud " in "Installing System Options."
10. Install the cover. See " Replacing the Cover ."
11. Stand the system upright.
12. Install the bezel. See " Installing the Bezel ."
13. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
14. Run Quick Tests in the system diagnostics. See " Running System Diagnostics ."
If the tests fail or the problem persists, see " Getting Help ."
Back to Contents Page
CAUTION: See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.