Dell PowerEdge 700 - Manual (Page 81)

For instructions, see the documentation that accompanied the drive.
2. Remove the bezel. See " Removing the Bezel " in "Troubleshooting Your System."
3. Open the hard-drive carrier handle. See Figure 7 -11 .
4. Insert the hard-drive carrier into the drive bay. See Figure 7 -11 .
5. Close the hard-drive carrier handle to lock it in place.
6. Install the bezel. See " Installing the Bezel " in "Troubleshooting Your System."
7. Install any required SCSI device drivers.
8. Run the SCSI controllers tests and the hard drive tests in the system diagnostics. See " Running System Diagnostics ."
If the hard drive fails the hard drive tests or does not operate properly, see " Getting Help ."
Installing a RAID Controller Card
See " Installing an Expansion Card " in "Installing System Components" for instructions about installing the card.
Back to Contents Page
NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so can damage the partially installed
carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is fully installed.
NOTE: Install a RAID controller card in expansion slot 3, 4, or 5. If you install both a RAID controller card and an Ultra 3 SCSI controller card, install the
RAID controller card in expansion slot 5. See Figure A -3 to identify the expansion slots.