Dell PowerEdge 700 - Manual (Page 57)

Back to Contents Page
Installing System Options
Dell™ PowerEdge™ 700 Systems Installation and Troubleshooting Guide
Cooling Shroud
System Fans
Memory Modules
Processor
Expansion Cards
System Battery
This section describes how to remove and install the following components:
l Cooling shroud
l System fans
l Memory modules
l Processor
l Expansion cards
l System battery
Cooling Shroud
The cooling shroud provides cooling for the processor and heat sink.
Removing the Cooling Shroud
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Remove the bezel. See " Removing the Bezel " in "Troubleshooting Your System."
3. Lay the system on its right side.
4. Remove the cover. See " Removing the Cover " in "Troubleshooting Your System."
5. Disconnect the power cables and hard-drive interface cable connectors from the SCSI backplane (if applicable) or hard drives.
6. Press the shroud release tab on the back panel toward the top of the system. See Figure 6 -1 .
7. Gently lift the cooling shroud away from the system board.
Figure 6-1. Removing the Cooling Shroud
CAUTION: See your System Information Guide for complete information about safety precautions working inside the computer and protecting
against electrostatic discharge.