Dell OptiPlex XE (Early 2010) - Manual (Page 29)

Back to Contents Page
Primary Hard Drive
Dell™ OptiPlex™ XE Service Manual— Desktop
Removing the Primary Hard Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the optical drive .
3. Remove the secondary hard drive .
4. Press in the blue tabs located on either side of the hard drive, and slide the hard drive assembly toward the back of the computer.
5. Lift the hard drive assembly and place it on the power supply.
6. Disconnect the hard-drive power and data cables from the hard drive.
7. Remove the hard drive assembly from the computer.
8. Pull the blue latches to release the hard drive, and lift the hard drive up and away from the hard drive assembly.
Replacing the Primary Hard Drive
To replace the primary hard drive, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.