I/o panel, Removing the i/o panel, Replacing the i/o panel – Dell OptiPlex XE (Early 2010) User Manual
Page 34
Back to Contents Page
I/O Panel
Dell™ OptiPlex™ XE Service Manual—
Desktop
Removing the I/O Panel
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
front panel
.
3.
Remove the
optical drive
.
4.
Remove the
secondary hard drive
.
5.
Remove the
primary hard drive
.
6.
Disconnect the I/O panel cable from its connector on the system board.
7.
Remove the screws that secure the I/O panel to the chassis.
8.
Remove the I/O panel from the computer.
Replacing the I/O Panel
To replace the I/O panel, perform the above steps in reverse order.
Back to Contents Page
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.