Dell OptiPlex XE (Early 2010) - Manual (Page 4)

This option is disabled by default.
Limit CPUID Value Enables or disables the CPUID limit.
This option is disabled by default.
Virtualization Support
Virtualization Enables or disables Intel® Virtualization technology.
This option is disabled by default.
VT for Direct
I/O
Enables or disables the Virtual Machine Monitor (VMM) from utilizing the additional hardware capabilities provided by Intel Virtualization
technology for direct I/O.
This option is disabled by default.
Security
Administrative
Password
Provides restricted access to the computer's system setup program in the same way that access to the system can be restricted
with the System Password option.
This option is not set by default.
System Password Displays the current status of the system's password security feature and allows a new system password to be assigned and
verified.
This option is not set by default.
Password Changes Enables or disables the user from changing the system password without the administrative password.
This option is enabled by default.
CPU XD Support Enables or disables the execute disable mode of the processor.
This option is enabled by default.
Computrace(R) Enables or disables the optional Computrace® service designed for asset management.
You can set this option to:
l Deactivate (default)
l Disable
l Activate
SATA-0 Password
SATA-1 Password
Displays the current status of the password set for the hard drive connected to the SATA-0 connector on the system board.
You can also set a new password. This option is not set by default.
NOTE: The system setup program displays a password for each of the hard drives connected to your system board.
Power Management
AC Recovery Determines how the system responds when AC power is re-applied after a power loss. You can set the AC Recovery to:
l Power Off (default)
l Power On
l Last State
Auto On Time Sets time to automatically turn on the computer.
Time is kept in the standard 12-hour format (hours:minutes:seconds).
Change the startup time by typing the values in the time and AM/PM fields.
NOTE: This feature does not work if you turn off your computer using the switch on a power strip or surge protector or if Auto
Power On is set to disabled.
Low Power Mode Enables or disables low power mode.
This option is disabled by default.
NOTE: When low power mode is enabled, the integrated network card is disabled.
Remote Wakeup Allows the system to power up when a network interface controller receives a wake up signal. You can set Remote Wakeup to:
l Disable (default)
l Enable
l Enable with Boot NIC
Suspend Mode Sets the power management suspend mode to: