Palm rest – Dell Inspiron 510m User Manual
Page 29
Back to Contents Page
Palm Rest
Dell™ Inspiron™ 510m Service Manual
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
keyboard
.
3.
Remove the
display assembly
.
4.
Remove the three M2.5 x 5-mm screws labeled "circle P" from the top of the palm rest.
5.
Remove the M2.5 x 5-mm screw labeled "M2.5x5" from the metal shield.
6.
Turn over the computer and remove the 13 M2.5 x 8-mm screws.
CAUTION:
Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1 M2.5 x 5-mm screws labeled "circle P" (3)
2 top of the palm rest
3 M2.5 x 5-mm screw labeled "M2.5x5"