Dell Inspiron 510m - Manual (Page 36)

Back to Contents Page
Speakers
Dell™ Inspiron™ 510m Service Manual
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the keyboard .
3. Remove the display assembly .
4. Remove the palm rest .
5. Remove the speaker cable from the speaker-cable routing clip.
6. Disconnect the speaker connector from the system board connector.
7. Remove the M2.5 x 5-mm screw labeled "M2.5x5" from the speakers.
8. Gently pull out on the front plastic computer base while pulling up the speakers.
9. Remove the reserve battery from the speakers.
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the speaker cable when inserting it back into the routing clip, slightly bend open the clip with your finger, insert the cable,
and then press the clip closed.
NOTICE: Handle the speakers with care to avoid damaging them.
1 reserve battery 5 speaker latches
2 M2.5 x 5-mm screw labeled "M2.5x5" 6 computer base
3 speaker 7 system board connector
4 speaker connector 8 speaker-cable routing clip