Dell PowerVault MD3220 User Manual

Page 80

Advertising
background image

80

Configuration: About Your Storage Array

• Adding an SNMP address—In Community name, type the

community name. In

Trap destination, type the trap destination, and

click

Add.

NOTE:

The community name is an American Standard Code for Information

Interchange (ASCII) string that identifies a known set of network management

stations and is set by the network administrator. The default community name

is the string “public”.The trap destination is the IP address or the host name of

a computer running an SNMP management application. An example of a

SNMP enabled management application is the Dell Management Console. For

more information on Dell Management Console, see dell.com.

• Replacing an SNMP address—Select the SNMP address in the

Configured SNMP addresses area, type the replacement community

name in

Community name and the trap destination in Trap

destination, and click Replace.

• Deleting an SNMP address—Select the SNMP address in the

Configured SNMP addresses area, and click Delete.

• Validating an SNMP address—Select the SNMP address in the

Configured SNMP addresses area, and click Test. A test message is

sent to the SNMP address. A message box with the results of the

validation and any error information is displayed.

4 Click OK.

An alert icon is displayed next to each node in the Tree view for which an

alert is set.

Follow these guideline for SNMP alerts:

• Any SNMP addresses that you had previously configured are displayed in

the Configured SNMP addresses area.

• The SNMP Community Name is determined by the system administrator

and configured within the a management application, such as the Dell

Management Console. More information about the Dell Management

Console is available at

dell.com.

• You can configure multiple SNMP addresses before you click OK.

book.book Page 80 Tuesday, June 18, 2013 2:53 PM

Advertising
This manual is related to the following products: