Dell 2407WFP Monitor User Manual
Page 39
Back
Wide Mode
H Position
V Position
Sharpness
Zoom
Horizontal Pan
Vertical Pan
Pixel Clock
Phase
Audio Option
Display Info
Display Reset
Exit Menu
Push
to go back to the main menu.
Adjust the image ratio as 1:1, aspect or full screen.
NOTE:
Wide Mode adjustment is not required at optimal preset resolution 1920 x 1200.
Use the
and
buttons to adjust image left and right. Minimum is '0' (-). Maximum is '100' (+).
Use the
and
buttons to adjust image up and down. Minimum is '0' (-). Maximum is '100' (+).
This feature can make the image look sharper or softer. Use
or
to adjust the sharpness from '0' to '100' .
Use the Zoom function to zoom in to specific area of interest.
Using the
and
keys to zoom in and out.
After zooming in, the horizontal and vertical pan function allows you to pan the enlarged image left/right and up/down respectively.
Use the
and
buttons to adjust image left and right. Minimum is '0' (-). Maximum is '100' (+).
Use the
and
buttons to adjust image up and down. Minimum is '0' (-). Maximum is '100' (+).
The Phase and Pixel Clock adjustments allow you to adjust your monitor to your preference. These settings are accessed through the main OSD menu, by selecting
'Image Settings'.
Use
the
and
buttons to adjust
for best image quality.
If satisfactory results are not obtained using the Phase adjustment, use the Pixel Clock (coarse) adjustment and then use Phase (fine), again.
NOTE:
Pixel Clock and Phase Adjustments are only available for "VGA" input.
To turn on or off Audio Power during Power Save mode.
All the settings related to this monitor.
Reset the image to the original factory setting.
Push
to exit the OSD main menu.
MENU
SETTINGS
Back
Language
Menu Horizontal Position
Menu Vertical Position
Menu Timer
Push
to go back to the main menu.
Language option to set the OSD display to one of five languages (English, Espanol, Francais, Deutsch, Japanese).
and
buttons move OSD left and right.
and
buttons move OSD up and down.
OSD Hold Time: Sets the length of time the OSD will remain active after the last time you pressed a button.
Use the
and
buttons to adjust the slider in 5 second increments, from 5 to 60 seconds.