Dell 2407WFP Monitor - Manual (Page 41)

OSD Warning Messages
PIP/PBP Contrast
PIP/PBP Hue/Tint
PIP/PBP Saturation
Exit Menu
Adjust the contrast level of the picture in PIP/PBP Mode.
reduce the contrast
increases the contrast
This function shifts the color of PIP/PBP image to green or purple. This is used to adjust for desired flesh tone color.
shifts image color towards green
shifts image color towards purple
Adjust the color saturation of PIP/PBP image.
makes the image look more monochrome
makes the image look more colorful
Push to exit the OSD main menu.
Your monitor will prompt you to achieve the best performance when you select PBP. You may see the following messages under certain combinations of input
sources in PBP mode.
or
When the monitor does not support a particular resolution mode you will see the following
message :
This means that the monitor cannot synchronize with the signal that it is receiving from the
computer. See
Monitor Specifications for the Horizontal and Vertical frequency ranges addressable
by this monitor. Recommended mode is 1920 X 1200.
You will see the following message before the DDC/CI function is disabled.
When monitor enters Power Save mode, the following message appears :
Activate the computer and wake up the monitor to gain access to the OSD
If you press any button other than the power button one of the following messages will appear depending on the selected input:
VGA / DVI-D input Video Input
or
In PIP mode, when the monitor does not sense the selected second signal input, one of the following messages will appear depending upon the selected
input as long as the OSD screen is closed.
1. VGA 2. DVI-D 3. S-Video 4. Composite