Dell PowerVault 745N - Manual (Page 10)

10
Rack Installation Guide
www
.dell.com | support.dell.com
Figure 3. One Rack Unit
CAUTION:
If you are installing more than one system, install the slide assemblies so that the first
system is installed in the lowest available position in the rack.
To mark the rack, perform the following steps:
1 Place a mark on the rack’s front vertical rails where you want to locate the bottom of the
system you are installing in the rack cabinet.
The bottom of each 1-U space is at the middle of the narrowest metal area between holes
(marked with a horizontal line on some rack cabinets—see Figure 3).
2 Place a mark 44 mm (1.75 inches) above the original mark you made (or count up three holes
in a rack that meets EIA-310 standards) and mark the rack’s front vertical rails with a
felt-tipped marker or masking tape (if you counted holes, place a mark just above the top hole).
This mark or piece of tape indicates where the system’s upper edge will be located on the
vertical rails (see Figure 4).
1 U (44 mm or 1.75 inches)
12.7 mm (0.5 inch)
15.9 mm (0.625 inch)
15.9 mm (0.625 inch)
12.7 mm (0.5 inch)