Dell PowerVault 745N User Manual
Page 26
26
Rack Installation Guide
www
.dell.com | support.dell.com
5
Secure each front center mount bracket (by its nuts and shoulder washers) finger tight on
their opposite slide assemblies using the two shoulder washers and two nuts you removed in
step 2 (see Figure 17).
6
Join the front brackets you just installed to the bracket on the slide assembly with the two
12-24 x 0.5-inch pan-head Phillips screws you removed in step 2 (see Figure 17).
The joined bracket becomes the new extended rear bracket.
7
Repeat steps 4 through 6 to configure the other slide assembly.
Figure 17.
Rotating the Front Mounting Bracket for Flush-Mount Installation
8
Holding the left slide assembly into position in the rack at the location you marked, adjust
the extended rear bracket tightly against the back of the vertical two-post rack and secure it to
the rail with two 12-24 x 0.5-inch Phillips screws (see Figure 18).
nuts (2 per bracket)
shoulder washers
(2 per bracket)
12-24 x 0.5-inch pan-head Phillips screws
(remove 2 per bracket)
NOTE: These screws are shown reinstalled on
other slide assembly.
12-24 x 0.5-inch pan-head Phillips
screws (install 2 per bracket)
mounting flange