Dell PowerVault 745N - Manual (Page 24)

24
Rack Installation Guide
www
.dell.com | support.dell.com
3 Repeat steps 1 and 2 to install the left slide assembly in the rack.
Figure 15. Installing the Slide Assemblies for Center-Mount Configuration
4 Install the stiffening bracket into the appropriate holes at the back of the slide assemblies and
secure the bracket with a 12-24 x 0.5-inch pan-head Phillips screw on each slide assembly
(see Figure 16).
If the vertical rack is 3 inches wide, use the holes at the back end of the slide assemblies
(shown in Figure 16). If the vertical rack is 6 inches wide, use the holes located 3 inches in
front of the holes at the back end of the slide assemblies.
12-24 x 0.5-inch
pan-head Phillips screws
(4 per slide assembly)
two-post open-frame rack
slide assembly
slide release latch