Dell PowerVault 745N User Manual
Page 11
Rack Installation Guide
11
Figure 4.
Marking the Vertical Rails
Installing the RapidRails Slide Assemblies
1
At the front of the rack cabinet, position one of the RapidRails slide assemblies so that its
mounting-bracket flange fits between the marks or tape you placed on the rack (see Figure 5).
The mounting hook on the slide assembly’s front mounting bracket flange should enter the
top hole between the marks you made on the vertical rails.
2
Push the slide assembly forward until the mounting hook enters its respective square hole on
the vertical rail, and then push down on the mounting-bracket flange until the mounting
hooks seat in the square holes and the push button pops out and clicks.
3
At the back of the cabinet, pull back on the mounting-bracket flange until the mounting hooks
are located in their respective square holes, and then push down on the mounting-bracket
flange until the mounting hooks seat in the square holes and the push button pops out
and clicks.
4
Repeat steps 1 through 3 for the slide assembly on the other side of the rack.
5
Ensure that the rails are mounted at the same position on the vertical rails on each side of
the rack.
tape on
vertical rail