Dell POWEREDGE M1000E - Manual (Page 213)

Fabric OS Administrator’s Guide 213
53-1002745-02
Authentication policy for fabric elements
7
Secret key pairs for DH-CHAP
When you configure the switches at both ends of a link to use DH-CHAP for authentication, you
must also define a secret key pair—one for each end of the link. Use the secAuthSecret command
to perform the following tasks:
• View the WWN of switches with a secret key pair.
• Set the secret key pair for switches.
• Remove the secret key pair for one or more switches.
Characteristics of a secret key pair
• The secret key pair must be set up locally on every switch. The secret key pair is not distributed
fabric-wide.
• If a secret key pair is not set up for a link, authentication fails. The “Authentication Failed”
(reason code 05h) error will be reported and logged.
• The minimum length of a shared secret is 8 characters and the maximum length is 40
characters. If the E_Port is to carry in-flight encrypted traffic, a shared secret or at least 32
characters is recommended. See
Chapter 14, “In-flight Encryption and Compression” for
details about in-flight encryption.
NOTE
When setting a secret key pair, note that you are entering the shared secrets in plain text. Use a
secure channel (for example, SSH or the serial console) to connect to the switch on which you are
setting the secrets.
Viewing the list of secret key pairs in the current switch database
1. Log in to the switch using an account with admin permissions, or an account with the O
permission for the Authentication RBAC class of commands.
2. Enter the secAuthSecret -- show command.
The output displays the WWN, domain ID, and name (if known) of the switches with defined
shared secrets:
WWN DId Name
-----------------------------------------------
10:00:00:60:69:80:07:52 Unknown
10:00:00:60:69:80:07:5c 1 switchA
Note about Access Gateway switches
Because Domain ID and name are not supported for Access Gateway, secAuthSecret --show output
for Access Gateway appears as follows:
WWN DId Name
-----------------------------------------------
10:00:8C:7C:FF:03:9E:00
-1 Unknown
10:00:8C:7C:FF:03:9E:01 -1 Unknown
10:00:8C:7C:FF:0D:AF:01 -1 Unknown
When setting and removing the secret for a switch or device on Access Gateway, only the WWN can
be used.