Hard drive, Removing the hard drive – Dell Studio 1450 (Mid 2009) User Manual

Page 25

Advertising
background image

Back to Contents Page

 

Hard Drive

  

Removing the Hard Drive

  

Replacing the Hard Drive

 

 

 

 

 

 

 

Removing the Hard Drive

 

1.

Follow the procedures in

Before You Begin

.


 

2.

Remove the battery (see

Removing the Battery

).


 

3.

Remove the base cover (see

Removing the Base Cover

).


 

4.

Remove the two screws that secure the hard drive to the computer base.

 

5.

Slide the hard drive away from the connector using the pull-tab.

WARNING:

If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION:

To help prevent damage to the system board, remove the main battery (see

Removing the Battery

) before working inside the

computer.

CAUTION:

To prevent data loss, turn off your computer (see

Turning Off Your Computer

) before removing the hard drive. Do not remove the hard

drive while the computer is On or in Sleep state.

CAUTION:

Hard drives are extremely fragile. Exercise care when handling the hard drive.

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 

is not covered by your warranty.

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking

tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.

NOTE:

Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.

NOTE:

If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard

drive (see the Dell Technology Guide).

NOTE:

The pull-tab on your hard drive may vary in appearance.

1

hard drive

2

pull-tab

3

screws (2)

 

 

Advertising