Dell PowerEdge SC 430 - Manual (Page 52)

9. Connect the interface cable from the drive to the IDE connector on the system board to the drive. See Figure 6 -8 and Figure A -3 .
10. Close the system. See " Closing the System " in "Troubleshooting Your System."
11. Replace the front drive bezel. See " Removing and Replacing the Front Drive Bezel " in "Troubleshooting Your System."
12. Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
13. Enter the System Setup program and ensure that the drive's IDE controller is enabled. See "Using the System Setup Program" in your User's Guide.
14. Test the drive by running the system diagnostics. See " Running the System Diagnostics ."
Back to Contents Page