Dell PowerVault DR2000v - Manual (Page 13)

ID Issue Description Workaround/Solution
icon next to the WAN interface.
Click the Advanced tab.
NOTE: It is recommended to
check the 'Fragment outbound
packets larger than WAN
MTU' if the MTU is set below
the default of 1500. Use the
'Update' button to process the
changes entered. Reboot
Sonicwall to make the change
effective.
2. Fragment Packet Handling should be
enabled.
3. Pre-shared Key mismatch should be
checked.
4. Check the gateway IP address and
firewall name or serial number specified
in the VPN policy on each end of the
tunnel.
5. Disable the hardware accelerator from
the diagnostics page.
6. Lower the encryption settings.
7. Check the upstream device
configuration.
8. Check for the NAT Traversal option.
9. On the computer where GVC is installed,
make sure the NAT Traversal option is
disabled under Connection Properties --
> Peers --> Edit --> NAT - Traversal.
21468 If the IP address
changed you could not
modify a broken
replication connection
in the GUI. Corrected in version 3.1.1.
21405 A Solaris client running
made an invalid request
to UDP which caused
the DR to go into
Maintenance Mode. Corrected in version 3.1.1.
21382 Adding a machine to
Global View did not
work under some rare
conditions due to
invalid characters
getting persisted into
the config file. Corrected in version 3.1.1.
21349 Replication Disconnect
Alerts could occur Corrected in version 3.1.1.
13