Dell PowerEdge 1800 - Manual (Page 8)

6
Installing the Tower-to-Rack and Rack-to-Tower Kits
www
.dell.com | support.dell.com
Tower-to-Rack Kit Instructions
NOTE:
For instructions on how to install the rack-to-tower kit, see "Rack-to-Tower Kit Instructions."
This section provides instructions on how to install the tower-to-rack kit. After you install this kit
on your system, see the documentation that came with your rack kit for instructions on how to
install the system into the rack.
The tower-to-rack kit includes the items listed below. See Figure 1-1.
• Two rack handles with attached thumbscrews.
• One rack-adapter plate.
• Six hex-head Phillips screws.
• Six slide-shoulder screws.
Figure 1-1. Tower-to-Rack Kit Contents
Removing the Bezel
1 Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet.
2 Rotate the four bottom-panel system stabilizer feet inward. and lay the system on its side. See
Figure 1-2.
3 Use the system key to unlock the front bezel.
4 Slide the latch down and pull the right edge of the bezel away from the front panel.
rack handles (2)
hex-head Phillips
screws (6)
slide-shoulder
screws (6)
rack-adapter plate
P2648bk0.book Page 6 Thursday, October 14, 2004 11:18 AM