Dell OptiPlex Gxi - Manual (Page 83)

Removing and Replacing Parts on the Low-Profile Chassis 4-19
Microprocessor/Heat Sink Assembly
Figure 4-18. Microprocessor Securing-Clip Removal
To remove the microprocessor/heat sink assembly, follow these steps:
1. Remove the microprocessor securing clip from the microprocessor/heat
sink assembly.
Press down on the folded part of the clip with a small screwdriver to release
the clip.
2. Push outward and then upward on the microprocessor-socket release
lever to rotate the lever to its fully vertical position (see Figure 4-19).
3. Lift the microprocessor/heat sink assembly out of its socket.
WARNING: The microprocessor chip can get extremely hot during
system operations. Be sure the chip has had sufficient time to cool
before touching it.
microprocessor securing clip
(hooks over tabs on the
socket)
heat sink
microprocessor socket
front of computer