Dell OptiPlex Gxi - Manual (Page 96)

5-10 Dell OptiPlex GXi Systems Service Manual
Figure 5-8. 5.25-Inch Drive Assembly Removal
To remove a 5.25-inch drive assembly from the middle or lower drive bay, fol-
low these steps:
1. Disconnect the DC power cable and the interface cable from the back of
the drive.
2. Press in on the two retaining tabs (one on each side of the drive), and
slide the drive assembly forward to remove it.
3. Remove the four screws attaching the 5.25-inch drive to the mounting
plate, and lift the drive out of the mounting plate (see Figure 5-9).
Figure 5-9. 5.25-Inch Drive Removal
When you replace the 5.25-inch drive, align the front of the drive flush with the
tab at the front of the mounting plate. Insert the four screws, and tighten them in
the order stamped on the bottom of the 5.25-inch drive-mounting plate.
retaining tabs (2)
screws (4)
align the front of the drive
flush with the tab at the
front of 5.25-inch drive-
mounting plate