Dell OptiPlex Gxi - Manual (Page 87)

Removing and Replacing Parts on the Midsize Chassis 5-1
Chapter 5
Removing and Replacing Parts
on the Midsize Chassis
T
his chapter provides procedures for removing the components, assemblies,
and subassemblies in the Dell OptiPlex GXi midsize computer. If you are ser-
vicing a Dell OptiPlex GXi low-profile or mini tower computer, use Chapter 4,
“Removing and Replacing Parts on the Low-Profile Chassis,” or Chapter 6,
“Removing and Replacing Parts on the Mini Tower Chassis.”
Unless otherwise noted, each procedure assumes the following:
• You have performed the steps in “Precautionary Measures” found later in
this chapter.
• You have removed the computer cover.
• You can replace or reinstall a part by performing the removal procedure in
reverse order unless additional information is provided.
R
ecommended Tools
Most of the procedures in this chapter require the use of one or more of the fol-
lowing tools:
• Small flat-blade screwdriver
• Wide flat-blade screwdriver
• #1 and #2 Phillips-head screwdrivers
•
1/4 -inch nutdriver
• Tweezers or long-nose pliers
Also, use a wrist grounding strap as explained in the next section, “Precaution-
ary Measures.”