Installing an internal scsi tape backup unit, Of the way of the center fans. see figure 3-15, See figure 3-15 – Dell PowerEdge 1900 User Manual
Page 68
68
Installing System Components
Figure 3-15.
Installing and Removing the Half-Height Tape Backup Unit or Optical Drive
Installing an Internal SCSI Tape Backup Unit
This subsection describes how to configure and install an internal SCSI tape backup unit.
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the
components inside the system. See your Product Information Guide for complete information about safety
precautions, working inside the computer, and protecting against electrostatic discharge.
1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical
outlet.
2 Remove the front bezel, if attached. See "Removing the Bezel" on page 46.
3 Open the system. See "Opening the System" on page 48.
1
SCSI ribbon cable
2
power cable
3
release latch
4
peripheral bay
5
half-height tape backup unit or
optical drive
1
4
2
3
5