Figure 3-27, D. see figure 3-27 – Dell PowerEdge 1900 User Manual
Page 96
96
Installing System Components
7 Disconnect the control panel cable from the back of the control panel. See Figure 3-27.
NOTICE:
Do not pull on the cable to unseat the connector. Doing so can damage the cable.
a
Squeeze the metal tabs on the ends of the cable connector.
b
Gently work the connector out of the socket.
8 Remove the display module:
a
Insert the end of a paper clip into the hole on the right side of the display module and gently
pry the label off.
b
Using a T10 Torx driver, remove the two screws that secure the display module to the system
chassis.
c
Remove the display module from the chassis cutout.
Figure 3-27.
Removing the Control Panel Assembly
1
screws (3)
2
control panel board
3
control panel cable
4
system chassis
5
display module cable
6
display module
7
display module screws (2)
8
display module label
6
5
4
2
3
7
8
1